硫酸钙晶须增强磷酸镁涂层研究论文图7与相关文本学术更正

《Materials》:Correction: Zheng et al. Calcium Sulfate Whiskers Dual-Enhance Mechanical and Anti-Corrosion Properties of Magnesium Phosphate Coatings. Materials 2026, 19, 1032

【字体: 大 中 小 】 时间:2026年09月24日 来源:Materials 3.7

编辑推荐:

   图7错误更正在原始出版物中1,图7存在错误。更正后的图7如下所示: 图7. 涂层的电化学性能。(a)养护28天后涂层样品的Tafel曲线;(b)等效电路模型;(c)涂层样品的Nyquist

  
图7错误更正
在原始出版物中1,图7存在错误。更正后的图7如下所示:
图7. 涂层的电化学性能。(a)养护28天后涂层样品的Tafel曲线;(b)等效电路模型;(c)涂层样品的Nyquist图及高频区域局部放大图;(d)测试样品的Bode图。
文本更正
原始出版物中1存在若干错误。第3.4节和第4节的部分文本需要更新。
在第3.4节第4段中,以下句子:"Figure 7c displays the Nyquist plots for the coated samples. All samples exhibit similar characteristics, consisting of a capacitive arc in the high-frequency region and a linear slope in the low-frequency region. This behavior is indicative of a diffusion-controlled corrosion process, where the gradient of the low-frequency slope corresponds to the coating's resistance against ion diffusion [10]. The capacitive arc observed at high frequencies represents the charge-transfer processes occurring at the interface, which are directly related to the kinetics of electrochemical surface reactions [60]. Among the samples, C3 displays the largest capacitive arc radius in the high-frequency region. Since a larger radius signifies higher charge-transfer resistance, this result demonstrates that the incorporation of 15 wt.% CSW effectively impedes the charge-transfer steps on the steel surface, thereby significantly reducing the corrosion rate." 已更新为:"Figure 7c displays the Nyquist plots for the coated samples from a representative EIS replicate. All samples exhibit similar characteristics, consisting of a capacitive arc in the high-frequency region and a linear slope in the low-frequency region. The capacitive arc observed at high frequencies corresponds to the coating layer response, governed by the coating capacitance in parallel with the coating resistance (Rf), which reflects the integrity of the physical barrier against electrolyte permeation [60]. Among the samples, C3 displays the largest capacitive arc radius in the high-frequency region. Since a larger radius signifies higher coating resistance (Rf), this result demonstrates that the incorporation of 15 wt.% CSW effectively enhances the physical barrier properties of the coating. It should be noted that the triplicate EIS measurements exhibited some degree of variability in the low-frequency impedance response, which is attributable to the inherent microstructural heterogeneity of spray-applied cementitious coatings (e.g., local variations in interfacial adhesion and pore distribution). Nevertheless, the fitted equivalent circuit parameters (Table 4), which integrate information across the full frequency range, consistently identify C3 as possessing the optimal balance of coating resistance (Rf = 157.03 Ω·cm2) and overall corrosion protection."",即更正后的中文内容为:"图7c展示了代表性电化学阻抗谱(EIS)重复实验中各涂层样品的Nyquist图。所有样品均表现出相似的特征,包括高频区域的容性弧和低频率区域的线性斜率。高频区域观察到的容性弧对应于涂层层的响应,由涂层电容与涂层电阻(Rf)并联决定,反映了涂层对电解质渗透的物理屏障完整性[60]。在各样品中,C3在高频区域表现出最大的容性弧半径。由于较大的半径意味着更高的涂层电阻(Rf),这一结果表明,掺入15 wt.% CSW有效地增强了涂层的物理屏障性能。需要注意的是,三次重复的EIS测量在低频阻抗响应方面存在一定程度的变异性,这归因于喷涂水泥基涂层固有的微观结构不均匀性(例如界面黏结力和孔隙分布的局部变化)。尽管如此,拟合的等效电路参数(表4)整合了全频段信息,一致表明C3具有最优的涂层电阻(Rf = 157.03 Ω·cm2)与整体腐蚀防护性能的平衡。"
在第3.4节第5段中,以下句子:"Figure 7d shows the Bode plots for each group of coated samples. The impedance modulus (|Z|) of all samples with different ratios exhibits typical characteristics as a function of frequency. In the low-frequency region (<1 hz), |z| decreases with increasing frequency, while in the high-frequency region (>103 Hz), |Z| tends to stabilize. In the Bode diagram, the impedance modulus at 0.01 Hz (|Z|0.01Hz) is an important parameter for determining the coating's shielding performance, with higher values corresponding to better protection against corrosive media [61]. The tested samples' |Z|0.01Hz values are ordered as follows: B is lower than C1, C2, C4, and C3. Specifically, the |Z|0.01Hz value of group C3 (15 wt.% CSW) is 124.8% higher than that of the unmodified MKP control B. Furthermore, when the CSW content was ≤15 wt.%, the MKP coating's shielding performance improved with higher content. However, when the CSW content reaches 20 wt.% (group C4), the coating's |Z|0.01Hz value significantly decreased. This decline is attributed to an excessive amount of whiskers, which disrupts the continuity of the cementitious network in the coating and thereby reduces its ability to block corrosive species [57]." 已更新为:"Figure 7d shows the Bode modulus plots for the same replicate presented in Figure 7c. The impedance modulus (|Z|) of all samples exhibits typical characteristics as a function of frequency. In the low-frequency region (<1 hz), |z| decreases with increasing frequency, while in the high-frequency region (>103 Hz), |Z| tends to stabilize. In the Bode diagram, the impedance modulus at 0.01 Hz (|Z|0.01Hz) is an important parameter for determining the coating's shielding performance, with higher values corresponding to better protection against corrosive media [61]. In the representative replicate shown, the |Z|0.01Hz values are ordered with C3 exhibiting the highest impedance among the modified coatings. Across the triplicate measurements, two of three replicates consistently showed C3 with the highest |Z|0.01Hz, while one replicate showed marginally elevated low-frequency impedance for the unmodified control (B), reflecting the inherent microstructural variability of spray-applied coatings. Overall, the low-frequency impedance trend supports the enhanced shielding performance of the 15 wt.% CSW formulation."",即更正后的中文内容为:"图7d展示了与图7c中同一重复实验的Bode模量图。所有样品的阻抗模量(|Z|)作为频率的函数表现出典型的特征。在低频区域(<1 Hz),|Z|随频率增加而减小,而在高频区域(>103 Hz),|Z|趋于稳定。在Bode图中,0.01 Hz处的阻抗模量(|Z|0.01Hz)是确定涂层屏蔽性能的重要参数,数值越高意味着对腐蚀性介质的防护越好[61]。在所示的代表性重复实验中,各样品的|Z|0.01Hz值排序中,C3在改性涂层中表现出最高的阻抗。在三次重复测量中,三次中的两次一致表明C3具有最高的|Z|0.01Hz值,而另一次重复实验中未改性对照组(B)的低频阻抗略有升高,这反映了喷涂涂层固有的微观结构变异性。总体而言,低频阻抗趋势支持了15 wt.% CSW配方的增强屏蔽性能。"
在第4节中,已在"Ultimately"一词之前添加以下句子:"While the EIS measurements exhibited inter-replicate variability consistent with the microstructural heterogeneity inherent to spray-applied cementitious coatings, the overall electrochemical and mechanical evidence consistently supports 15 wt.% CSW as the optimal formulation."",即:"尽管EIS测量表现出与喷涂水泥基涂层固有的微观结构不均匀性一致的重复间变异性,但整体电化学和力学证据始终支持15 wt.% CSW为最佳配方。"
作者声明科学结论未受影响。本次更正已获学术编辑批准。原始出版物也已同步更新。

参考文献

  1. Zheng, Y.; Chen, H.; Liu, Y.; Gao, X. Calcium Sulfate Whiskers Dual-Enhance Mechanical and Anti-Corrosion Properties of Magnesium Phosphate Coatings. Materials 2026, 19, 1032. [Google Scholar] [CrossRef] [Scilit] [PubMed]
免责声明/出版方声明: 所有出版物中contained的声明、观点和数据均为各作者和贡献者本人所有,不代表MDPI和/或编辑部的观点。MDPI和/或编辑部对内容中提及的任何理念、方法、说明或产品可能导致的任何人身或财产损失不承担责任。
相关新闻
生物通微信公众号
微信
新浪微博
  • 搜索
  • 国际
  • 国内
  • 人物
  • 产业
  • 热点
  • 科普

热点排行

    今日动态 | 人才市场 | 新技术专栏 | 中国科学人 | 云展台 | BioHot | 云讲堂直播 | 会展中心 | 特价专栏 | 技术快讯 | 免费试用

    版权所有 生物通

    Copyright© eBiotrade.com, All Rights Reserved

    联系信箱:

    粤ICP备09063491号